STANMECH Technologies Inc.
  • Home
  • Equipment Supply
    • Flooring
    • Geomembrane
    • Industrial Fabrics
    • Manufacturing
    • Plastic Fabrication
    • Roofing >
      • Distributors
  • Engineering Services
    • Engineering Services
    • Cosmetics
    • Deflashing Systems
    • Drying Bottles & Cans
    • Heat Systems
    • Shrinking Labels
  • Repair
    • Repair Service
    • Tech Tips
  • Resources
    • Articles
    • Case Studies
    • Engineering Information
    • Whitepapers
  • About
    • About Us
    • Technology Providers
  • Contact

Wiring Instructions for 230V GEOSTAR G5/G7, TWINNY T5/T7, UNIROOF AT/ST, VARIANT T1, and WELDPLAST S1/S2/S4

11/9/2021

 
Plug specifications:
  • 250 Volt; 20+ Amp; 2-pole; 3-wire; grounding; twist-lock
  • Example: Hubbell HBL2321 plug
  • This tool is single phase

When installing a plug:
  • Connect the green wire to the pin with the bent tab
  • Connect the white wire to one of the pins directly left or right of the bent tab
  • Connect the black wire to the other pin directly left or right of the bent tab
  • If using a 4 prong plug, leave the pin opposite the one with the bent tab disconnected
  • Screw down the wire contacts on to the bare electrical wire only and do not clamp down on the insulation of the wire. Bad contacts cause sparking which may cause the cord to heat up and may damage equipment.

Making an Extension Cord:
  • Use a 10 Gauge or thicker cable if you plan to make a 100 ft or longer extension cord

Generator Instructions:
  • Equipment must be switched off before turning the generator on or off
  • When using a generator make sure the plug is wired for A/C
  • Recommended Generator Size:
    • GEOSTAR G5/G7: 6,000W
    • TWINNY T5/T7: 7,000W
    • UNIROOF AT/ST: 7,000W
    • VARIANT T1: 7,000W
    • WELDPLAST S1: 4,000W
    • WELDPLAST S2: 6,000W
    • WELDPLAST S4: 7,000W

Comments are closed.
STANMECH Technologies Inc. 
​944 Zelco Drive Burlington ON L7L 4Y3 | 1-888-438-6324 | info@stanmech.com
Terms of Use    Privacy    Terms and Conditions of Sale    Warranty Policies 
Français

Proud Member of:
IFAI Logo
Industrial Fabrics Association International
IAGI Logo
International Association of Geosynthetic Installers
PEO Logo
Authorized by the Association of Professional Engineers of Ontario to offer professional engineering services. 
  • Home
  • Equipment Supply
    • Flooring
    • Geomembrane
    • Industrial Fabrics
    • Manufacturing
    • Plastic Fabrication
    • Roofing >
      • Distributors
  • Engineering Services
    • Engineering Services
    • Cosmetics
    • Deflashing Systems
    • Drying Bottles & Cans
    • Heat Systems
    • Shrinking Labels
  • Repair
    • Repair Service
    • Tech Tips
  • Resources
    • Articles
    • Case Studies
    • Engineering Information
    • Whitepapers
  • About
    • About Us
    • Technology Providers
  • Contact