Wiring Instructions 230V BITUMAT B2, VARIMAT V2, and WELDPLAST S6

Plug specifications:

• 250 Volt; 30+ Amp; 2-pole; 3-wire; grounding; twist-lock
• Example: Hubbell HBL2621 plug
• This tool is single phase

When installing a plug:

• Connect the green wire to the pin with the bent tab
• Connect the white wire to one of the pins directly left or right of the bent tab
• Connect the black wire to the other pin directly left or right of the bent tab
• If using a 4 prong plug, leave the pin opposite the one with the bent tab disconnected
• Screw down the wire contacts on to the bare electrical wire only and do not clamp down on the insulation of the wire. Bad contacts cause sparking which may cause the cord to heat up and may damage equipment.

Making an Extension Cord:

• Use a 10 Gauge or thicker cable if you plan to make a 100 ft or longer extension cord

Generator Instructions:

• Equipment must be switched off before turning the generator on or off
• When using a generator make sure the plug is wired for A/C
• Recommended Generator Size:
  • BITUMAT B2: 10,000W
  • VARIMAT V2: 10,000W