STANMECH Technologies Inc.
  • Home
  • Equipment Supply
    • Flooring
    • Geomembrane
    • Industrial Fabrics
    • Manufacturing
    • Plastic Fabrication
    • Roofing >
      • Distributors
  • Design Services
    • Design Services
    • Cosmetics
    • Deflashing Systems
    • Drying Bottles & Cans
    • Process Heat Systems
    • Shrinking Labels
  • Repair
    • Repair Service
    • Tech Tips
  • Resources
    • Articles
    • Case Studies
    • System Design Calculations
    • Whitepapers
  • About
    • About Us
    • Technology Providers
  • Contact

WELDPLAST Tech Tips

4/5/2017

 
Symptom: Display arrives at desired temperature but measured temperature is more than 30C lower than the set temperature
  • The element may be partially plugged: Make sure to clean off any plastic shavings and debris from your work table, or use the stand to prop up the extruder while not using it.  If the WELDPLAST lays down flat on the table for a length of time, shavings can get sucked in through the air intake and get stuck in the element, blocking the air flow.

Comments are closed.
STANMECH Technologies Inc. 
​944 Zelco Drive Burlington ON L7L 4Y3 | 1-888-438-6324 | [email protected]
Terms of Use    Privacy    Terms and Conditions of Sale    Warranty Policies 
Français

Proud Member of:
IAGI Logo
International Association of Geosynthetic Installers
  • Home
  • Equipment Supply
    • Flooring
    • Geomembrane
    • Industrial Fabrics
    • Manufacturing
    • Plastic Fabrication
    • Roofing >
      • Distributors
  • Design Services
    • Design Services
    • Cosmetics
    • Deflashing Systems
    • Drying Bottles & Cans
    • Process Heat Systems
    • Shrinking Labels
  • Repair
    • Repair Service
    • Tech Tips
  • Resources
    • Articles
    • Case Studies
    • System Design Calculations
    • Whitepapers
  • About
    • About Us
    • Technology Providers
  • Contact