STANMECH Technologies Inc.
  • Home
  • Equipment Supply
    • Flooring
    • Geomembrane
    • Industrial Fabrics
    • Manufacturing
    • Plastic Fabrication
    • Roofing >
      • Distributors
  • Engineering Services
    • Engineering Services
    • Cosmetics
    • Deflashing Systems
    • Drying Bottles & Cans
    • Heat Systems
    • Shrinking Labels
  • Repair
    • Repair Service
    • Tech Tips
  • Resources
    • Articles
    • Case Studies
    • Engineering Information
    • Whitepapers
  • About
    • About Us
    • Technology Providers
  • Contact

WELDMAX Tech Tips

4/6/2017

 
Warming up the WELDMAX before use:
  • The WELDMAX has a safety feature that protects it from extruding at too low a temperature. Generally, set the Plast temp. to 240 and the hot air to 300, then wait until the digital display stops flashing. Once the actual temp display is the same as the set display, the WELDMAX will stop flashing and the WELDMAX is ready to use. Do not set the Plast temp past the melting point of the plastic because over-heating of the extrudate inside the tool can cause a fire.

Changing the Welding Shoe:
  • Do not change the welding shoe when the tool is cold.
  • Do not twist or bend the welding shoe when sliding the welding shoe off the extrudate nozzle. Just slide the welding shoe off the ceramic nozzle after loosing the two set screws.
Cool Down of WELDMAX after use:
  • Turn down the hot air temperature to zero and continue to blow air thorough the WELDMAX until the hot air has reached room temperature. Do not turn off the WELDMAX with full heat on because you could damage the element.

Recommended Air and Plast Settings:
  • For both PE & PP set the Air to 300 and the Plast to 240

Wiring Instructions
Connecting a 120 V plug to your WELDMAX:
  • You must use a 15 Amp or higher plug
  • Connect the white wire to the silver connector
  • Connect the black wire to the bronze connector
  • Do not connect any wires to the ground pin of the plug

Comments are closed.
STANMECH Technologies Inc. 
​944 Zelco Drive Burlington ON L7L 4Y3 | 1-888-438-6324 | info@stanmech.com
Terms of Use    Privacy    Terms and Conditions of Sale    Warranty Policies 
Français

Proud Member of:
IFAI Logo
Industrial Fabrics Association International
IAGI Logo
International Association of Geosynthetic Installers
PEO Logo
Authorized by the Association of Professional Engineers of Ontario to offer professional engineering services. 
  • Home
  • Equipment Supply
    • Flooring
    • Geomembrane
    • Industrial Fabrics
    • Manufacturing
    • Plastic Fabrication
    • Roofing >
      • Distributors
  • Engineering Services
    • Engineering Services
    • Cosmetics
    • Deflashing Systems
    • Drying Bottles & Cans
    • Heat Systems
    • Shrinking Labels
  • Repair
    • Repair Service
    • Tech Tips
  • Resources
    • Articles
    • Case Studies
    • Engineering Information
    • Whitepapers
  • About
    • About Us
    • Technology Providers
  • Contact