Changing the element on a VARIMAT
Correct the nozzle position on a VARIMAT
Working with generators
The two hold-down assemblies and the green belt in the picture below keep the top layer of membrane flat on the bottom layer as it is heated by the nozzle, just before the drive tire presses down on it.
Each hold-down assembly contains the following parts:
Many of Leister’s tools utilize a lock pin to hold the nozzle in position during welding and cooldown. The lock pin is designed to snap if excessive force is put on the heater in order to prevent more expensive damage to the tool.
The most common reason for a lock pin to bend or break is the tool being lifted or carried incorrectly. The correct methods of carrying the tool are with both hands under the frame, or with one hand under the frame and the other holding the black carrying handle.
In this guide, parts will be referred to using the numbers indicated in the VARIMAT V drawing below. As an example, see lock pin (79).
Note: Always change both brushes at once. If one brush needs to be changed, change them both.
If you are having problems with your power cord or extension cord, follow this checklist to confirm your power source and check your plugs, sockets and power cord:
If your VARIMAT is not powering down completely but you suspect a power problem, check your power source.
If you're building an extension cord for your Leister automatic tool such as the BITUMAT, VARIMAT, or VARIANT T1, here are some things to keep in mind:
Have questions? Contact us at firstname.lastname@example.org or 905-631-6161 for help.