|
|
|
|
WELDPLAST Family Tips
-
 Symptom: Display arrives at desired temperature but measured temperature is more than 30C lower than the set temperature
The element may be partially plugged: Make sure to clean off any plastic shavings and debris from your work table, or use the stand to prop up the extruder while not using it. If the WELDPLAST lays down flat on the table for a length of time, shavings can get sucked in through the air intake and get stuck in the element, blocking the air flow.
-
Use the correct plug and wire, as detailed in the wiring instructions.
Still have questions? Send them to us via
info@stanmech.com
or call us at 905-631-6161.
Have a tip you've found useful? Let us know!
Submit a tech tip for inclusion on our website
.
|
|