|
|
|
|
FUSION Family Tips
-
The FUSION is not producing the correct heat
- Confirm that the correct element has been installed. The elements for the FUSION 2 and 3C are not the same as the element for the FUSION 3.
- Check that the air intake filter (located on the housing in front of the extrusion trigger) is clean. A plugged filter will reduce air flow and heat transfer and could cause the element to burn out. Remove any blockage in the filter with a soft brush.
-
Use the correct plug and wire, as detailed in the wiring instructions.
Still have questions? Send them to us via
info@stanmech.com
or call us at 905-631-6161.
Have a tip you've found useful? Let us know!
Submit a tech tip for inclusion on our website
.
|
|